In this quick tip video, Adam demos the use of a product that I’d never even heard of: Solder Seal Wire Connectors. These connectors allow you to make waterproof wire joins without having to twist and solder wires. You simply slot the wires into the clear plastic connector tube and hit it with a heat gun. The tube has solder inside for the electrical connection and it clamps and shrink-seals the wires at the same time.
Adam also extols the virtues of numbered wire marking tape. These are little labels, numbered 0-9, that you can use to mark and ID corresponding connections.
In this quick tip video, Adam demos the use of a product that I’d never even heard of: Solder Seal Wire Connectors. These connectors allow you to make waterproof wire joins without having to twist and solder wires. You simply slot the wires into the clear plastic connector tube and hit it with a heat gun. The tube has solder inside for the electrical connection and it clamps and shrink-seals the wires at the same time.
Adam also extols the virtues of numbered wire marking tape. These are little labels, numbered 0-9, that you can use to mark and ID corresponding connections.
OK now that we’ve gotten the motor up and running, and the drive selected in step 1 – we know our wiring is correct. step 2 is getting data out! unlike almost all protocols we’re used to, there’s no clock pin on floppy data. it comes out in MFM format (at least, this floppy disk format does) which means we get a series of ~500kHz open-drain pulses with short negative widths, and varying positive widths that indicate flux transitions. now the *proper* thing to do here is use a PLL to sync up with the pulses since the motor speed can vary a few %, then convert the pulse widths to bits of data. but we’re gonna do it dirty to start, and just busy-poll the pin using a fast register gpio read and collect pulse widths, then maybe decode and bitpack them on the fly. not sure if this is workable yet, but it looks OK so far: just started collecting the data pulses and they seem to be binnable.
part 1 is here (video), and post.
OK now that we’ve gotten the motor up and running, and the drive selected in step 1 – we know our wiring is correct. step 2 is getting data out! unlike almost all protocols we’re used to, there’s no clock pin on floppy data. it comes out in MFM format (at least, this floppy disk format does) which means we get a series of ~500kHz open-drain pulses with short negative widths, and varying positive widths that indicate flux transitions. now the *proper* thing to do here is use a PLL to sync up with the pulses since the motor speed can vary a few %, then convert the pulse widths to bits of data. but we’re gonna do it dirty to start, and just busy-poll the pin using a fast register gpio read and collect pulse widths, then maybe decode and bitpack them on the fly. not sure if this is workable yet, but it looks OK so far: just started collecting the data pulses and they seem to be binnable.
part 1 is here (video), and post.