A while ago I added the hall effect encoder IC I’ve been using directly to the motor controller PCB. The controller sits directly on the back of the motor (with a magnet added to the motor shaft), and the phase wires solder straight in. I also have a pair of board-mounted XT30 connectors on the DC bus for easy daisy-chaining. Otherwise, the board is basically identical to the previous version of this controller. I’ve now built over a dozen of these, and have had no problems.
I plan on doing another revision of this controller using the new replacement to the DRV8301/2, the DRV8323, which Austin has played around with already. That should let me shrink the controller even more. I also plan on designing some general-purpose mounting brackets that fit a wide variety of hobby motors, to make it really easy to strap these controllers on the back of basically any small motor. In a similar vein, I’ve also mostly written an auto-tuner for automatically measuring motor parameters for tuning the current loops. I’ve verified that the measurement works, but haven’t integrated it with the rest of my motor control code yet.
Once I get those things done, it should be super easy for me to throw all the small motors I have onto the motor dyno and fill out the motor database quite a bit.
For testing and easy dyno-ing I machined some mounts for attaching the controller on the back of my T-Motor U8’s and U8 knock-offs. This isn’t the intended use of this controller, but I’ll get into that in a later post.
from Adafruit Industries – Makers, hackers, artists, designers and engineers! http://ift.tt/2EVdt9z
via IFTTT
Комментариев нет:
Отправить комментарий